Radio Shack 26 137 User Manual

Illuminated USB 2.0

4-Port Hub

26-137

AC/DC Power Adapter

Wide end connects

to your 4-port hub.

Introduction

USB 2.0 Cable

Thank you for purchasing the RadioShack Illuminated USB 2.0 4-Port Hub.

You can connect and power up to four peripheral USB devices, and the ports

light up when power is connected. The hub’s transmission rate is 40 times

faster than USB 1.1, meaning it can support devices that require high speed

transmissions, such as scanners, DVD drives, digital cameras, and others.

In order to reach USB 2.0 speed, your computer or host adapter card must

have USB 2.0 support. The hub is also backwards compatible with USB 1.1.

Narrow end connects

to your PC.

System Requirements

• Windows 98SE/ME/2000/XP

4-Port Hub

• PC or notebook with Pentium 233 MMX or higher and one available

USB port

• At least 64 MB RAM

Installation

1. Plug the AC adapter's barrel plug into the

hub’s 5V 2.4A jack, and plug the other

end into a standard AC outlet.

3. Plug the USB cable's A-type connector into your PC's host port or

upper level hub. Hub installation starts automatically. If not, follow

the instructions that appear on your computer screen to manually

complete installation.

7. Select Generic USB Hub. The Generic USB

Properties screen appears with this message,

"This device is working properly." Receipt of

this message indicates successful hub

installation.

4. To verify installation, click on Start/Settings/Control Panel/

System on your computer.

5. Select the Hardware tab, and then click Device Manager.

2. Plug the USB cable's mini A-type connector

into the hub’s host port.

6. Select Universal Serial Bus controllers from the list that

appears. All connected USB devices are listed.